Hackensack NJ Furnace and Air Conditioning Repair Installation Service

Received a call that the boiler was making a loud noise and that it gotten turned off. Upon arrival cycled it on and found that the main circulator pump was making a lot of noise from the bearing assembly. I confirmed that it was the bearing and optimotor, I lubricated all three ports and allowed the oil to sit. Recycled it several times and the pump is no longer making noise. We are going to monitor the pump going forward to see if it still needs to be replaced or if the bearing was salvaged by lubrication.

Received a call that the furnace was not operating, upon arrival I found that the combustion lower was running but there was no flame. Upon further investigation, I found that as soon as the furnace attempted to call for heat and a signal was sent to the spark ignitor that the board would shut itself down and recycle. It did this several times, I removed the board and I replaced both the circuit board and the spark igniter. Installed both new items and cycled the furnace, was able to get the circuit board to spark a little bit longer but it would still shut down. I found that the coil in the gas valve was shorted which caused the initial failure of the circuit board, I replaced the gas valve with an OEM valve and cycle the furnace. The furnace is now running and operating properly.

Received a call at the first floor furnace was not operating, upon arrival I found that there was no display on the thermostat and there were no lights on the board. Removed the panels and found that the control voltage fuse on the circuit board had failed, installed a resettable breaker and cycled the system to see if I could locate the cause of the fuse failure. The house was 64° upon startup, I allowed the thermostat to operate and reach 70° and there was no fault in the furnace. I installed a new three amp fuse and recycled the system, the furnace lit properly and is operating. Upon removal of the failed fuse I noticed that there was no black spot in the middle of the fuse that is typically present when a fuse blows. It is possible that the fuse failed without an overcurrent incident. The furnace is operating properly at this time. I left a spare fuse on the furnace service switch just in case we need it in an emergency situation.

HVAC Repair Service – A homeowner reported strange noises coming from their HVAC system. Upon investigation, we found a loose motor mount causing vibrations. We secured the motor, eliminating the noise and restoring smooth operation. We also informed the homeowner about our maintenance plans to help prevent future issues.

Between 10:40-11:00 Arrival; "Outside condenser sounds like it is going to blow up" There is an ongoing venting issue on 2nd or 3rd floor as well. I spoke with Christopher.

Struggling with a malfunctioning thermostat? Get relief from extreme temperatures with Climate Plus LLC. Our professional technicians can help diagnose and repair any issues, ensuring your home stays comfortable. Contact us today for top-notch service.

Went out to a residential home for an air conditioning repair. The air conditioning unit had stopped cooling, leaving the home uncomfortably warm. Upon inspection, discovered that there was a malfunctioning compressor. After replacing the compressor, the air conditioning system was restored to full functionality.

HVAC repair. Went out to a customer's home to address heat complaints on the first floor when the thermostat was set to 67 degrees cool. Upon inspection, found that the air filter was dirty and clogged, causing reduced airflow and inadequate heating. The dirty air filter was replaced and the system was tested.

Former estimate in SF notes: 11/01/23: Dual Capacitor Turbo200 $277.94, Super Hard Start Kit SPP8 Up to 5 Ton $148

9am Arrival; No cooling. I did not add a diagnostic assuming a possible commercial contract

9am Arrival; Maintenance.

Maintenance on York gas fired furnace